The handling of standard operating procedures for good manufacturing practices was inadequate.
Inspection Record
Menasha Packaging Canada L.P. — Health Canada Inspection Findings
View the regulator's official source The source document is always the basis for judgement.
Findings
The electronic system was not validated for its intended use.
Investigations into deviations, reports, and/or follow-up actions were inadequate. The change control system was inadequate for ensuring changes are properly documented, evaluated, and/or approved.
The handling of raw materials, products, or packaging materials in keeping with pre-approved written procedures or instructions was inadequate.
The temperature and/or humidity control was inadequate.
The assessment, recording, follow-up, and/or investigation of complaints and/or other information about potentially defective products was inadequate.
The availability, content and/or maintenance of the quality agreements between the supplier, fabricator, tester, packager, labeller, distributor, importer, and/or wholesaler was inadequate.
About this record
Extracted automatically from the document of the Health Canada inspection on 2025-09-23. The source is available at the link above.
This is a record of that moment. Inspection findings are usually followed by the company's response and corrective action, but this page does not know how that turned out. Do not read it as the current state; check the regulator's official announcements for the latest status.
Translation and classification are automated and may differ in nuance from the source.
